The 90° V-shaped fitting is primarily used at the structural corners of a glass facade or enclosure. It anchors two panels that meet at a perpendicular angle, or it is used on corner support posts to brace edge panels effectively.

This spider fitting is cast from high-quality stainless steel. Depending on your project requirements, it can be supplied in SUS304 for general interior and exterior use, or SUS316 for environments requiring superior corrosion resistance, such as coastal areas or highly industrialized zones.

Yes. Point-supported systems require precision holes to be drilled (and often countersunk, depending on your choice of routel) into the tempered glass panels prior to installation.

The GW-F200-2V refers to the 2-way 90° spider arm body itself. Articulated glass bolts (routels) are purchased separately because the required bolt length and type depend entirely on the thickness and specification of your glass panels (e.g., 12mm tempered vs. insulated double-glazed units).

The central hole on the GW-F200-2V allows the fitting to be bolted securely to a primary structural backing, such as a corner steel post, structural fin, or a tension cable truss system, transferring the weight and wind loads safely to the building's framework.